Gourt Home::Gourt :: Backplane
A backplane is a circuit board (usually a printed circuit board) that connects several connectors in parallel to each other, so that each pin of each connector is linked to the same relative pin of all the other connectors, forming a computer bus. It is used as a backbone to connect several printed circuit board cards together to make up a complete computer system. One popular early computer system that used this approach was called the S-100 bus because the connectors used had one hundred pins. Some computers like the Apple II and the IBM PC integrated an internal backplane for expansion cards.
Backplanes are normally used in preference to cables because of their greater reliability. In a cabled system, the cables need to be flexed every time that a card is added to or removed from the system; and this flexing eventually causes mechanical failures. A backplane does not suffer from this problem, so its service life is limited only by the longevity of its connectors. For example, the DIN 41612 connectors used in the VMEbus system can withstand 50 to 500 insertions and removals (called mating cycles), depending on their quality.
Active vs. passive
Backplanes have grown in complexity from the simple ISA (Industry Standard Architecture used in the original IBM PC) or S-100 style where all the connectors were connected to a common bus. Because of limitations inherent in the PCI specification for driving slots, backplanes are now offered as passive and active. Passive backplanes offer no active bus driving circuitry. Active backplanes include chips which buffer the various signals to the slots.
In any case, a backplane is generally differentiated from a motherboard by the lack of on-board processing power where the CPU is on a plug-in card.
Backplanes in Storage
Backplanes have also become common place for connecting multiple hard drives to a single disk controller. Backplanes are commonly found in disk enclosures, disk arrays, and even in some servers.
"Backplane"