Tumble polishing, or tumbling, is a technique for smoothing and polishing a hard substance. Within the field of metalwork, this is known under the term of barrelling, or barrel polishing, and is subtly different, but operated under the same principles.

For tumbling of rocks, as a lapidary technique, a plastic or rubber barrel is loaded with consignment of rocks, all of similar, or the same hardness, and some abrasive grit and a lubricant. Silicon carbide grit is commonly used here, and water is the universal lubricant. The barrel is then placed slowly rotating rails so that a round barrel will rotate at about $\backslash frac\{132.8\}\; \{\backslash sqrt\{Din\}\}$ (where Din is the inside barrel diameter in inches) RPMs or a hexagon barrel will rotate at about $\backslash frac\{79.7\}\; \{\backslash sqrt\{Din\}\}$ RPMs Raymond Rodebaugh/Alan Silverstein. Big Tumbler, December 17, 1999, p. 10.

This causes the load of rock to slide past each other, with the abrasive grit between the rock. The result of this depends on the coarseness of the abrasive, and the duration of the tumble.

Typically, a full tumble polish from rough rock to polish takes around 4-5 weeks, and is done in 4 steps. Initially smoothing is done with a coarse grit (such as 80 mesh), followed by washing and use of finer grits (220 then 400 mesh) before the use of a polishing compound (such as cerium oxide or ferric oxide). The precise time is determined by many factors, including the hardness of the rock, and the degree of smoothing desired in the coarser steps.

During the 1970s, small rock tumblers were a common hobby item, and jewelry decorated with tumbled semi-precious stones was very much in fashion. Likewise, dishes and decorative glass jars filled with tumbled stones (often including common rocks not suitable even for costume jewelry) were frequently used as household ornaments.

For barreling metals, a barrel with internal veins, typically rubber, is used. The work parts are placed in the barrel, along with polished steel shot, and a solution of a barreling soap. The soap acts as a lubricant, and to prevent the rusting of the metals, whilst the material is tumbled as for rocks. Only one stage is used, although the length of time determines the final polishing.

Stained glass shards used for mosaic glass are also tumbled. No abrasive is used to avoid clouding the glass, only water as a lubricant to remove the sharp edges so that the glass may be handled safely. As little as 8 hours tumbling may be sufficient for tumbled glass.

These techniques, although they take a long time, involve very little operator intervention, and thus are very cheap. Small tumblers (one pound capacity) are available and inexpensive for home/hobbyist use. Additionally, very large barrels can be used, allowing a lot of work to be done at once for professional use. The main disadvantage is its limited scope - stones will be smooth, and have semi-random shapes (like pebbles from the beach), and metals need to be relatively simple shapes, with no fine work.

Sometimes, stone preforms are used. This refers to cutting shapes from the rough rock, before tumbling. This gives more control over the final piece, so shapes such as a tear drop could be produced. It is still limited to rounded shapes. Preforms may use less time with the coarsest step, or skip it altogether.

Tumbling is used to polish and smooth dice for recreational use, this has the unfortunate effect of making their sides and faces somewhat uneven and making the dice less than fair. Lou Zocchi's Gamescience company is known for making dice without tumbling them; the edges as a result of these dice are very, very sharp but the dice are guaranteed to be fair.

References