Gourt Home::Gourt :: MOS Technology 6510
The MOS Technology 6510 is a microprocessor designed by MOS Technology, Inc., and is a direct successor of the very successful 6502.
The primary change from the 6502 was the addition of an 8-bit general purpose I/O port (only six I/O pins were available in the most common version of the 6510). In addition, the address bus was made tristate-able.
The 6510 was only widely used in the Commodore 64 home computer (and in significantly smaller numbers in the C64's portable version, the SX-64). In both the C64 and SX-64 the extra pins of the processor were used for bank switching, and in the C64 also for controlling the electric motor of the Datassette tape recorder.
Variants
In 1985 MOS produced the 8500, an HMOS version of the 6510. Other than the process change, it is virtually identical to the NMOS version of the 6510. The 8500 was originally designed for use in the modernised C64, the C64C. However in 1985, limited quantities of 8500s were found on older NMOS based C64s. It finally made its official debut in 1987, appearing in a motherboard using the new 85xx HMOS chipset.
The 7501/8501 variant of the 6510 was used in Commodore's C16, C116 and Plus/4 home computers, and the 2 MHz-capable 8502 variant was used in the Commodore C128. All these CPUs are opcode compatible (including undocumented opcodes, except the 8502, where some differences concerning the undocumented opcodes have been reported).
The Commodore 1551 disk drive used the 6510T, a version of the 6510 with eight I/O lines. The NMI and RDY signals are not available.
External links
"MOS Technology 6510"